کدهای خطای MID 250

The fault code is registered only if the codes PSID17, PSID18, SID231, SID251, SID254 are active and disappears after the faults for these codes are eliminated.

The SWM unit registers a fault in the SAE J1939 data channel. The data channel wires are shorted to power or ground.

The SWM unit supply voltage exceeds 36 V for more than 5 seconds. The generator is faulty, or the engine was started from an external power source.

The SWM unit supply voltage is below 9 V for more than 5 seconds. There is a break in the power supply wire or a short to ground.

The SWM unit is faulty.

The button has been pressed for more than one minute or the button is faulty.

The button has been pressed for more than one minute or the button is faulty.

The button has been pressed for more than one minute or the button is faulty.

The button has been pressed for more than one minute or the button is faulty.

The button has been pressed for more than one minute or the button is faulty.

The button has been pressed for more than one minute or the button is faulty.

The voltage at the SWM unit output to the button block is higher than 14 V for more than 5 seconds. There is a short circuit to higher voltage in the wires between the SWM unit and the button block.

The voltage at the SWM unit's output to the button block is below 7 V for more than 5 seconds. There is a break in the wire between the SWM unit and the button block.

Broken wire between the SWM unit and the button unit.

The voltage at the SWM unit output to the button unit is less than 1 V for more than 5 seconds. There is a short to ground in the wires between the SWM unit and the button unit.

The SWM unit has not received a signal from the button unit for more than 30 seconds, or the signal received from the button unit is invalid. The data link between the SWM unit and the button unit is broken or partially damaged.