کدهای خطای MID 136

The modulator is faulty; power to the modulator is disconnected until internal operations are completed (e.g., disconnecting the batteries with the ignition on). Clear the error codes; if the problem persists, replace the modulator.

The modulator is faulty, the EBS unit is faulty. If one modulator is faulty, replace it. If multiple modulators are faulty, replace the EBS unit.

The modulator, modulator wiring, or EBS unit is faulty. Clear the error codes, check the modulator wiring, and if the problem persists, replace the modulator.

The modulator has been replaced with one with a different part number. Check the modulator part number and reprogram the EBS unit.

Damaged, leaky, or clogged modulator or brake cylinder lines; insufficient air flow to the modulator; faulty modulator; clogged modulator muffler. Check the air lines, modulator muffler, and modulator inlet air pressure. Try restart #1.

The wire between the ABS and VECU units is shorted to positive. Check the wiring between these units.

There is a break in the wiring between the ABS and VECU units. Check the wiring between these units.

Short circuit of the wire between the ABS and VECU units to negative.

Short circuit of the wire between the ABS unit and the ABS electromagnetic valve to positive.

Fuse No. 2 (basic version) or No. 3 (full version) for the power supply of the electromagnetic valves has burned out, or the power supply wire of the ABS unit is broken.

ABS unit ground wire broken.

Short circuit to ground in the solenoid valve wires.

The ABS unit is faulty.

The wheel speed sensor is not connected correctly. Check the wiring and connectors for all speed sensors. Make sure the right and left speed sensors are not reversed. To reset the code, after correcting the problem, perform reset #3.

Short circuit to negative in the wire, broken wire between the ABS unit and the lamp, damaged lamp holder, burned out lamp.

The wire from the lamp to the EBS unit is shorted to positive. Check the lamp control wire for shorts.

The wire from the lamp to the EBS unit is shorted to negative, and the LED in the switch is faulty. Check the lamp control wire and the TCS switch wires for an open circuit.

Clogged, pinched, or leaking air tubes, or a faulty modulator. Check the air supply to the modulators. Note: SID57 applies to the front

Clogged, pinched, or leaking air tubes, or a faulty modulator. Check the air supply to the modulators. Note: SID57 applies to the front

Damaged wiring, loose connector, internal fault in the trailer modulator, faulty modulator, faulty EBS unit. Check the wiring between the EBS unit and the trailer brake control modulator.

The modulator configuration is incorrect, the wires are damaged, or the EBS unit is faulty. Check the wiring and connectors.

Short circuit of modulator wires to positive, damaged wires, internal fault in the EBS unit.

The wiring is damaged, the modulator is faulty, the control unit is faulty. Check the power wires and data channel wires between the modulator and the EBS unit.

The wiring is damaged, the modulator is faulty, the EBS unit is faulty.